Nutrients & Fertilizer

Promote healthy roots and robust root growth in hydroponically grown plants. Will kill algae and other unwanted pathogens due to its strong oxidative properties.

Contents: 50% H2O2

Directions : Apply 1ml of the 50% solution per 5L of hydroponic solution.

CAUTION : HIGHLY CORROSIVE, HANDLE WITH CARE, STORE RESPONSIBLY

Whether you are a novice or an expert, growing indoors or outdoors, the EHG products will provide the nutrient profile you require for every stage of your plants’ growth.

Use in conjunction with EHG range of nutrients. Using EHG products as directed will provide a balanced nutrient profile for every stage of your plant’s growth.

EHG Ph Up and Ph Down are cost effective solutions to keeping your Ph at the required levels. They are concentrated solutions therefore add relatively small amounts at a time to bring your reservoir to the required level. With practice you will have a fairly good idea of how much Ph up or down is required. Using EHG nutrients as per the nutrient guide will generally drop water from a neutral Ph of 7 to a Ph of around 6 which is ideal for many plants, nonetheless, proper control and monitoring remains essential.

Proper PH control after mixing is vital at a range of around 5.6 to 6.5, to ensure nutrient uptake. Nutrients that claim to be PH buffered can be ineffective. There is no substitute for proper PH monitoring. Use EHG PH up or PH down to maintain the required level.

In recirculating systems, as your plants take up nutrients the PH will change and it must be corrected. Check PH on at least a daily basis unless you are completely familiar with the PH changes of your growing system. Change your reservoir solution at least once a week. PH colour test kits are inexpensive and reliable.

EHG (Easy Hydro Grow) products are fully registered under the department of agriculture and are ideal for local South African conditions at a fraction of the price of similar imported nutrients. EHG products also show better performance than their more expensive imported competitor products. The products are extremely easy to use, easy to measure and mix instantly and are manufactured from the purest mineral salts so they are rapidly absorbed by  plants.

The nutrient guides which can be downloaded below gives you detailed instructions on which nutrients and in which quantities to mix with water at the different stages of plant development.

DOWNLOADS

EHG (Easy Hydro Grow) - PH Up / PH Down Directions for use

EHG (Easy Hydro Grow) - Product Brochure

EHG (Easy Hydro Grow) - Nutrient Guide Flowering Plants

EHG (Easy Hydro Grow) - Nutrient Guide Non Flowering Plants

Important Notes on use of products :

• Store in a cool, dark, dry area.
• Shake well before use.
• Pour each component of your mix separately into your water reservoir and do not mix them together in their concentrated form.
• Balance the PH of the water in the reservoir after adding formulas and before feeding. 

For further info on this product and other EHG (Easy Hydro Grow) products, please feel free to browse the EHG (Easy Hydro Grow) website.

 Available in 500ml and 1L bottles.

The T.A - Terra Aquatica (Formerly GHE - General Hydroponics Europe) range.

FlashClean originally GHE Flora Kleen is a unique, high performance rinse and soil conditioner for all substrates and systems.

From rejuvenating houseplants to maximising yields and potential in commercial hydroponics, FlashClean is one of the most powerful tools available to gardeners!

Eventually, every growing system will develop fertilizer residue as a natural part of the growing process. This accumulation results in salt build-up that can block drippers, cause unsightly accumulations on the top of soil or substrate, and will eventually cause your plants undue stress and even root damage. With the highly concentrated nutrients available today, and high EC levels running in many systems, nutrient lockout can also be an invisible limit on your grow; FlashClean® solves all these problems and more:

• Dissolves accumulated fertiliser salts
• Corrects nutrient balance
• Treats nutrient lock out
• Nourishes microbial life and refreshes soil and coco coir
• Maximises final stage growth (especially with Ripen)

Specifically developed to dissolve mineral salts, FlashClean® releases nutrient bonds between minerals and substrate and allows you to rinse excess residue. This release also helps plants make the most of remaining fertilizers, especially in the crucial week just before harvest.

Unlike other “flushes” and finishing products on the market, FlashClean® is not an acid, isn’t enzyme based, and does not dump magnesium or other mineral additives into your system – this makes it uniquely flexible: with FlashClean® you can give your system, and your plants, a clean slate at any time and at any stage of the growth process. No matter what type of growing system you’re using

– indoors or outdoors, soilless or hydroponic, pots or garden beds, FlashClean® is easy to use: just mix with pH adjusted water and apply.

In recirculating hydroponic systems:

• To reset and refresh before changing nutrients (inc. before FinalPart®): Add 1.5 to 3 ml / L of FlashClean® to your existing nutrient solution and circulate for 24 hours before draining and replacing with fresh nutrient solution. Use the lower dosage for young or fragile plants, and the higher dosage for established plants / close to harvest.
• After nutrient burn or lock-out: Drain old nutrient solution, add 1.5 to 3 ml / L of FlashClean® to pH adjusted water (you don’t need to use a full tank, just enough to circulate freely and run the system). Circulate for 24 hours before draining and adding new, fresh nutrient solution. Use the lower dosage for young or fragile plants, and the higher dosage for established plants.
• As a final rinse (after FinalPart®): Drain old nutrient solution, add 1.5 to 3 ml / L of FlashClean® to pH adjusted water (you don’t need to use a full tank, just enough to circulate freely and run the system). Circulate for for the last two days before harvest to increase sugar levels in your crop instead of losing aroma and medicinal content with a long water flush..

In potting soil & soilless mixes inc. Coco Coir:

• To reset and refresh before changing nutrients (inc. before FinalPart®), and after nutrient burn or lock-out: Every fifteen days (or when needed after lock out etc): fill a watering can with fresh pH adjusted water and add 1.5 to 3 ml / L of FlashClean®. Drench until there is runoff from the bottom of the pot. Resume your regular fertiliser schedule with the next watering. Use the lower dosage for young or fragile plants, and the higher dosage for established plants.
• As a final rinse / after FinalPart®: Use 3 ml / L of FlashClean® instead of nutrients during the last two days before harvest to increase the sugars level in your crop instead of losing aroma and medicinal content with a long water flush.

NB: FlashClean® can be used at any stage of growth or flowering but do not use FlashClean® more than once every two weeks.

Use FlashClean® with :

All nutrients and substrates, but above all: FinalPart®:

FlashClean® helps FinalPart work to its full potential. By rinsing residues of nitrogen and other salts out of your substrate, FinalPart can get to work more effectively mobilizing nitrates and improving taste in your final crop.

When you’re done, instead of a 10-day flush with water after FinalPart®, try 2 with FlashClean® - growers around the world have, because in commercial production, 8 days per harvest is a big bonus! 

Terra Aquatica's complete feed chart can be found at this link.

Available in 500ml, 1L & 5L bottles.

Overcome trace element deficiency in plants with the fulvic chelated micro-nutrient mix.

Contents: Fe, Mn, Mo, B, Cu, Zn, Ca, Mg, Fulvic acid

Fulvic Acid is a powerful, all-natural, tried and tested agricultural input. Because of its small molecular size and powerful chelating properties, it is best used as a foliar spray to combat or prevent nutrient deficiencies.

Contents: 100g/kg

Combat blossom end rot with fulvic chelated calcium. Keeps calcium in a bio-available form to ensure optimal uptake.

Contents: 4g/kg Ca, 0.5g/kg N, 0.08g/kg B, 6g/kg fulvic acid

VitaLink ESSENTIALS pH Down 250ml (81% Phosphoric Acid) is a quality adjuster necessary to control the pH of nutrient solutions. Concentrated for the professional grower.

VitaLink ESSENTIALS pH Up is a quality adjuster necessary to control the pH of nutrient solutions. Concentrated (50% Potassium Hydroxide) for the professional grower.

Liquid silica supplement that improves general plant health and disease tolerance. Contents: 9.3% Si, 6.3% K

Contents: 100g/kg